PDF version here

JICEC05
Jordan International Chemical Engineering Conference V
12-14 Sebtember 2005, Amman, Jordan
 

THE TITLE: MANUSCRIPT PREPARATION FOR JICEC05 PAPERS
 

Authors' names
Authors' affiliations
Authors' addresses
Authors' e-mails:
 

ABSTRACT

The JICEC05 Proceedings will be produced directly from the electronic WORD files you provide. Please prepare your paper in WORD following the guidelines given below and submit via e-mail. Make sure that your paper is free of technical, grammatical and typographical errors.

INTRODUCTION

Each paper, including figures and tables, should be limited to 10 pages for General Papers and 12 pages for Keynote Papers. The paper should be single-sided in two columns only with a typing area of 175mmx245mm.

ORGANIZATION

A short abstract should state briefly the content, methods and results only. Define abbreviations and acronyms the first time they are used. Avoid footnotes at the bottom of the page within the frame.

Structure of Paper

Papers should have the following structure: Title, Name(s) of author(s) and affiliation, Abstract, Main Text, Conclusions, Acknowledgements (if appropriate), Nomenclature, References, Appendices (if appropriate)

Heading Categories

·         TITLE (type in bold capitals)

·         MAIN SECTIONS (type in bold capitals)

·         Sub-headings (type in bold lower case)

Formatting

Use A4 or letter-sized paper, set top margin at 22mm and bottom margin at 28mm; left and right margins at 17mm. The column width is 83mm. The space between the two columns is 10mm. Justify both columns.

Fonts

Title: 11 point Arial or Helvetica, bold, all capitals.

Author: 10 point Arial or Helvetica, italic.

Affiliation: 9 point Arial or Helvetica, lower case.

Main text: 9.5 or 10 point Arial or Helvetica.

Units and Equations

Use SI unit only. Equations should be typed. In the text, equation should be referred to as Eq.(1). Align left each equation and allow single spacing above and below, as:

                                                 (1)

Tables, Figures and Photographs

Briefly and descriptively title each table and caption each figure. Place table title above the table and figure caption below the figure. Each table and figure should be referred to in the text (e.g., Fig. 1, Table 1); and placed in the order referred to and as close as possible to the first reference in the text. Allow single spacing between the table or figure and the adjacent text, and no space between the table title and table (or between figure caption and figure). Tables and figures should be numbered consecutively with single Arabic numerals.

Table 1. Experimental data.

Fig.1.  Sketch of the sample.

Do not reduce figures or tables to a size that is difficult to read. References should be cited in the text by author and year (Smith, 1983). 

RESULTS AND DISCUSSION

All the results obtained should be discussed in detail.

CONCLUSIONS

State the main findings in brief only.

Acknowledgement

Acknowledgement comes here.

NOMENCLATURE

A          area, m²

c_p         specific heat, J/kg°C

h          heat transfer coefficient, W/m²°C

Greek Letters

r          density, kg/m³

Subscripts

f           surrounding fluid

Superscripts

*           reference condition

Book: Kreith, F. and J. Kreider. 1978. Principles of Solar Engineering. New York:Hemisphere-McGraw-Hill.

Contribution to a Book: Chianelli R. R., M. Daage, and M. J. Ledoux. 1994. Fundamental studies of transition-metal sulfide catalytic materials. In Advances in Catalysis, Vol. 40, edited by D. D. Eley, H. Pines, and W. O. Haag. Burlington, Mass.: Academic Press.

Website: www.igec.uwaterloo.ca. Accessed on October 29, 2005.